Shelf supports
en
21
a
Once the cleaning aid has run through to the end,
an audible signal sounds.
Note:
If flashes in the display when the cleaning aid
is switched on, this indicates that the cooking compart-
ment has not completely cooled down. Switch off the
appliance. Wait until the cooking compartment has
cooled down and switch the cleaning aid back on.
Recleaning the cooking compartment
ATTENTION!
The prolonged presence of moisture in the cooking
compartment leads to corrosion.
▶
After using the cleaning aid, wipe the cooking com-
partment clean and allow it to dry fully.
1.
Open the appliance door and remove the remaining
water with an absorbent sponge cloth.
2.
Clean the smooth surfaces in the cooking compart-
ment with a dish cloth or a soft brush. Stubborn
residues can be removed using a stainless steel
scouring pad.
3.
Remove limescale with a cloth soaked in vinegar.
Then wipe with clean water and rub dry with a soft
cloth (including under the door seal).
4.
If you are unable to remove stubborn dirt, repeat the
cleaning aid after the cooking compartment has
cooled down.
5.
To switch off, turn the function selector to the zero
setting.
6.
Open the appliance door to the stop position (ap-
prox. 30°) for approx. one hour to allow the sur-
faces in the cooking compartment to dry thoroughly.
‒
You can also dry the cooking compartment
quickly.
"Drying the cooking compartment quickly",
Drying the cooking compartment quickly
1.
After the cleaning aid has completed, open the ap-
pliance door to the stop position (approx. 30°).
2.
Start
CircoTherm hot air
at 50 °C.
3.
After five minutes, switch off the appliance and
close the appliance door.
16 Shelf supports
To clean the rails and the cooking compartment, or to
replace the rails, you can remove these.
16.1 Detach the rails in the main cooking
compartment
WARNING ‒ Risk of burns!
The shelf supports get very hot
▶
Never touch the shelf supports when hot.
▶
Always allow the appliance to cool down.
▶
Keep children at a safe distance.
1.
Lift the rail forwards slightly and detach it .
2.
Pull the whole rail to the front and remove it.
16.2 Attaching the rails in the main cooking
compartment
Notes
¡
The rails only fit on the right or left.
¡
For both pull-out rails, ensure that you can pull them
forwards and out.
1.
First, push the rail into the middle of the rear
socket until the rail rests against the cooking
compartment wall, and then push this back .
2.
Push the rail into the front socket until the rail
also rests against the cooking compartment wall,
and then press this downwards .
3
4
16.3 Removing the pull-out rail
WARNING ‒ Risk of burns!
The shelf supports get very hot
▶
Never touch the shelf supports when hot.
▶
Always allow the appliance to cool down.
▶
Keep children at a safe distance.
ATTENTION!
The self-cleaning surfaces in the cooking compartment
may be damaged by detaching and attaching the pull-
out rails.
▶
Detach the rails before detaching or attaching the
pull-out rails.
Notes
¡
Depending on the appliance type, you must change
the basic settings for the telescopic rails for appli-
ances with rails and pull-out rails.
¡
If necessary, you can use pull-out rails on all levels.
