Twist-Pad with Twist knob
en
35
â
Hotplates with bridge heating element
Two individual hotplates can be interconnected with a
bridge heating element to create one large extended
cooking zone.
Under normal operation these hotplates both work as
normal single-circuit and dual-circuit hotplates.
To activate the bridge heating element: the single-circuit
hotplate must be switched off.
1.
Switch on the dual-circuit hotplate.
2.
Touch the
ð
symbol. The outer filament circuit on
the dual-circuit hotplate is activated. The display
lights up.
3.
Touch the
ð
symbol again. The extended cooking
zone is activated. The display lights up.
To deactivate the extended cooking zone: touch the
ð
symbol again. The display goes out. The extended
cooking zone is deactivated.
Note:
If you activate the extended cooking zone, the
outer filament circuit of the dual-circuit hotplate is
automatically deactivated.
Residual heat indicator
The hob has a two-stage residual heat indicator for
each hotplate.
If
•
appears in the display the hob is still hot. It may be
used, for example, to keep a small meal warm or to
melt cooking chocolate. As the hotplate cools down
further, the display changes to
œ
. The display remains lit
until the hotplate has cooled sufficiently.
j
Twist-Pad with Twist knob
Twist-Pad with Twist knob
The twistpad is the area in which you can use the twist
knob to select the hotplates and set heat settings. The
twist knob automatically centres itself in the twistpad
area.
The twist knob is magnetic and is placed on the
twistpad. Tapping the twist knob where there is a
marking activates the relevant hotplate. Turning the
twist knob selects the heat setting.
Note:
Always keep the twist knob clean. Soiling may
impair its function.
Removing twist knob
You can remove the touch knob. This makes cleaning
easier.
You can also remove the twist knob while the hotplate
is on. The wipe protection function is activated and the
hob switches off after 35 seconds.
Notes
■
The main switch is excluded from the wipe
protection function. You can switch off the cooktop
at any time.
■
If you mount the twist knob again and then turn it, the
wipe protection function will be switched off.
:
Warning – Risk of fire!
If you place a metallic object onto the twistpad, the
cooktop may continue to heat up. Always switch off the
cooktop using the main switch for this reason.
Storing the twist knob
The twist knob contains a strong magnet. Keep the twist
knob away from magnetic data carriers, such as video
cassettes, diskettes, credit cards or cards with
magnetic strips. Otherwise they may be damaged
beyond repair. They can also cause interference in
television sets and monitors.
:
Warning – Hazard due to magnetism!
For wearers of electronic implants, e.g. pacemakers or
insulin pumps. Implants may be affected by magnetic
fields. You should therefore never carry the twist knob in
a pocket. They must be kept at least 10 cm from
pacemakers.
Note:
The twist knob is magnetic. Metal particles which
stick to the underside can scratch the ceramic hob.
Always wipe the twist knob thoroughly.
Operation without the twist knob
If you have mislaid the twist knob, you can also operate
the hob without it:
1.
Switch on the hob using the main switch.
2.
Touch the
œ
symbol and
U
at the same time for 4
seconds. An audible signal sounds.
3.
Touch the
U
symbol repeatedly until the display for
the desired hotplate lights up.
4.
Press the
œ
(-) and (+)
x
buttons to select the heat
setting required.
The hotplate is switched on.
Note:
You can place the twist knob back on the
twistpad at any time.