Operating modes
en
13
Ç
Operating modes
Operating modes
This appliance can be used in air extraction mode or
circulating-air mode.
Exhaust air mode
Note:
The exhaust air must not be conveyed into a
functioning smoke or exhaust gas flue or into a shaft
which is used to ventilate installation rooms which
contain heat-producing appliances.
■
Before conveying the exhaust air into a non-
functioning smoke or exhaust gas flue, obtain the
consent of the heating engineer responsible.
■
If the exhaust air is conveyed through the outer wall,
a telescopic wall box should be used.
Circulating-air mode
Note:
To bind odours in circulating-air mode, you must
install an activated carbon filter. The different options for
operating the appliance in circulating-air mode can be
found in the brochure. Alternatively, ask your dealer.
The required accessories are available from specialist
outlets, from customer service or from the Online Shop.
j
Twist-Pad with Twist knob
Twist-Pad with Twist knob
The twistpad is the area in which you can use the twist
knob to select the hotplates and heat settings. The twist
knob automatically centres itself in the twistpad area.
The twist knob is magnetic and is placed on top of the
twistpad. To activate a hotplate, touch the twist knob at
the level for the required hotplate. Turning the twist
knob selects the heat setting.
Position the twist knob on the twist pad so that it is in
the centre of the indicators which delimit the twist pad
area.
Notes
■
Even if the twist knob is not entirely central, this will
not affect how the twist knob works.
■
Always keep the twist knob clean. Soiling may impair
its function.
Remove the twist knob.
If the twist knob is removed, the "Lock control panel for
cleaning" function is activated.
The twist knob can be removed during cooking. The
"Lock control panel for cleaning" function is activated
for 35 seconds. If the twist knob is not placed back in
position before this time elapses, the hob switches off.
:
Warning – Risk of fire!
If during this 35 seconds a metallic object is placed in
the twistpad area, the hob may continue to heat up.
Therefore, always switch off the hob using the main
switch.
Storing the twist knob
A strong magnet is located inside of the twist knob.
Keep the twist knob away from magnetic data carriers
such as credit cards and cards with magnetic strips.
Otherwise, these data carriers may be damaged
beyond repair.
The magnet could also cause faults on televisions and
screens.
Note:
The twist knob is magnetic. Metal particles stuck
to the bottom could scratch the surface of the hob.
Always clean the twist knob thoroughly.
The air which is drawn in is cleaned
by the grease filters and conveyed to
the exterior by a pipe system.
The air which is drawn in is cleaned by the
grease filters and an activated carbon filter
and conveyed back into the kitchen.
Summary of Contents for T5 L6E Series
Page 1: ...en INSTRUCTION MANUAL INDUCTION HOB WITH INTEGRATED VENTILATION SYSTEM T5 L6E...
Page 2: ...2 cm...
Page 51: ......