en
8
As soon as the rinse-aid refill indicator
H
is lit on the fascia, there is still a rinse-aid
reserve of 1 – 2 rinsing processes. Refill
with rinse aid.
The rinse aid is required for stain-free
utensils and clear glasses. Use only rinse
aid for domestic dishwashers.
Combined detergents with rinse-aid
component may be used up to a water
hardness of 21° dH (37° fH, 26° Clarke,
3.7 mmol/l) only. If the water hardness is
over 21° dH, rinse aid must be used.
–
Open the dispenser
1J
by pressing
and lifting the plate on the cover.
–
Carefully pour rinse aid up to the max.
mark in the filler opening.
–
Close cover until it clicks shut.
–
To prevent excessive foam formation
during the next rinse cycle, remove any
rinse aid which has run over with a
cloth.
Setting amount of rinse aid
The amount of rinse aid dispensed can be
set from
§
:
‹‹
to
§
:
‹‡
. This is the factory
setting
§
:
‹…
.
Do not change the amount of rinse aid
unless streaks (select lower setting) or
water stains (select higher setting) are left
on the utensils.
–
Close the door.
–
Switch on ON/OFF switch
(
.
–
Hold down programme button
#
and
press START button
`
until
•
:
‹
.... is
indicated on the digital display.
–
Release both buttons.
The LED for button
#
flashes and the
digital display
)"
displays the factory
setting
•
:
‹…
.
–
Press programme button
#
until the
factory set value
§
:
‹…
is indicated on
the digital display
)"
.
To change the setting:
–
Press programme button
3
.
Each time the button is pressed, the
set value increases by one level; when
the value of
§
:
‹‡
has been reached,
the display jumps back to
§
:
‹‹
(off).
–
Press START button
`
.
The set value is saved.
Switching off rinse aid refill
indicator
If the rinse-aid refill indicator
H
is
impaired (e.g. when using combined
detergents containing rinse aid
component), it can be switched off.
–
Proceed as described under “Setting
amount of rinse aid” and set the value
to
§
:
‹‹
.
The rinse aid refill indicator
H
is now
switched off.
Rinse aid
max
