Installation instructions
en
17
WARNING ‒ Risk of electric shock!
¡
It must always be possible to disconnect the appli-
ance from the electricity supply. The appliance must
only be connected to a protective contact socket
that has been correctly installed.
▶
The mains plug for the mains power cable must
be easily accessible after the appliance is in-
stalled.
▶
If this is not possible, an all-pole isolating switch
must be integrated into the permanent electrical
installation according to the conditions of over-
voltage category III and according to the installa-
tion regulations.
▶
The permanent electrical installation must only
be wired by a professional electrician. We recom-
mend installing a residual-current circuit breaker
(RCCB) in the appliance's power supply circuit.
¡
Sharp-edged components inside the appliance may
damage the connecting cable.
▶
Do not kink or trap the connecting cable.
¡
The connection data can be found in the rating plate
inside the appliance.
¡
To see the rating plate, remove the odour filter.
¡
The connecting cable is approx. 1.30 m long.
¡
This appliance complies with the EC interference
suppression regulations.
¡
The appliance corresponds to protection class 1.
Therefore, only use the appliance with a protective
earth connection.
¡
Do not connect the appliance to the power supply
during installation.
¡
Only a licensed professional may connect appli-
ances without plugs. They are subject to the require-
ments of the local electricity provider.
Installation
Checking the ceiling
1.
Check whether the ceiling is horizontal and ad-
equately load-bearing.
The max. weight of the appliance is 40 kg.
Do not fit the appliance directly onto plasterboard
(or similar lightweight materials) in a suspended
ceiling.
2.
Drill the borehole depth in accordance with the
length of the screws.
3.
Install the appliance with a material which is suffi-
ciently stable and has been adjusted accordingly for
both the structural conditions and the weight of the
appliance.
4.
Check the cut-out area for existing cables of other
appliances.
Preparing the ceiling
1.
Ensure that the stability of the ceiling is guaranteed
after the cut-outs have been made.
2.
Cover the hob to prevent damage.
3.
Saw a cut-out into the ceiling.
x
y
z
x
y
z
487
±1
888
±1
16 – 50
487
±1
1188
±1
16 – 50
4.
Remove any shavings.
Preparing the appliance
1.
Remove the grease filters.
To avoid causing damage, do not bend the grease
filters.
2.
Screw the flat duct connection onto the fan group.
Installing the appliance
WARNING ‒ Risk of injury!
¡
Components inside the appliance may have sharp
edges.
▶
Wear protective gloves.
¡
The appliance is heavy.
▶
To move the appliance, two people are required.
▶
Use only suitable tools and equipment.