en
Cleaning and maintenance
8
Saturation signal
The following will happen when the filters are saturated:
■
The
ª
symbol appears in the display: Clean the
metal grease filter
■
The
’
symbol appears in the display and a signal
sounds: Replace the activated charcoal filter
See the "CleanAir air recirculation module" printed
supplement or the section entitled
Resetting the saturation signal
When the fan is switched off, the signal is also switched
off.
The relevant filter(s) should be cleaned now if you have
not already done so.
Switching over the appliance to air recirculation
1.
Switch off the appliance.
2.
Press the
$
and
I
*
buttons on the control panel
at the same time until the
’
indicator lights up.Then
release the buttons.
The
’
indicator will go out shortly afterwards. The
electronic controller has now been switched over to air
recirculation mode.
Switching over the appliance to air extraction
Note:
The default setting is air extraction mode.
1.
Switch off the appliance.
2.
Press the
$
and
I
*
buttons on the control panel
at the same time until the
ª
indicator lights up.Then
release the buttons.
The
ª
indicator will go out shortly afterwards. The
electronic controller has now been switched over to air
extraction mode.
2
Cleaning and maintenance
Cleaning
and maint
enance
:
Warning – Risk of burns!
The appliance becomes hot during operation. Allow the
appliance to cool down before cleaning.
:
Warning – Risk of electric shock!
Penetrating moisture may result in an electric shock.
Clean the appliance using a damp cloth only. Before
cleaning, pull out the mains plug or switch off the circuit
breaker in the fuse box.
:
Warning – Risk of electric shock!
Do not use any high-pressure cleaners or steam
cleaners, which can result in an electric shock.
:
Warning – Risk of injury!
Components inside the appliance may have sharp
edges. Wear protective gloves.
Cleaning agents
To ensure that the different surfaces are not damaged
by using the wrong cleaning agent, observe the
information in the table. Do not use any of the following:
■
Harsh or abrasive cleaning agents,
■
Cleaning agents with a high alcohol content,
■
Hard scouring pads or cleaning sponges,
■
High-pressure cleaners or steam cleaners.
Wash new sponge cloths thoroughly before use.
Follow all instructions and warnings included with the
cleaning agents.
Area
Cleaning agent
Stainless steel Hot soapy water:
Clean with a dish cloth and then dry with a soft cloth.
Clean stainless steel surfaces in the grind direction
only.
Special stainless steel cleaning products are availa-
ble from our after-sales service or from specialist
retailers. Apply a very thin layer of the cleaning prod-
uct with a soft cloth.
Painted sur-
faces
Hot soapy water:
Clean using a damp dish cloth and dry with a soft
cloth/towel.
Do not use any stainless steel cleaners.
Aluminium
and plastic
Glass cleaner:
Clean with a soft cloth.
Glass
Glass cleaner:
Clean with a soft cloth. Do not use a glass scraper.
Controls
Hot soapy water:
Clean using a damp dish cloth and dry with a soft
cloth/towel.
Risk of electric shock caused by penetrating mois-
ture.
Risk of damage to the electronics from penetrating
moisture. Never clean operating controls with a wet
cloth.
Do not use any stainless steel cleaners.
