en
Ú
Installation instructions
You must note the following
Electrical connection:
Must only be carried out by a licensed
expert. Incorrect connection will invalidate the warranty.
Installation:
Must only be carried out by a professional. The
fitter is liable for any damage.
Hob and cooker:
Must only be from the same brand and have
the same combination feature.
Protection against accidental contact:
Must be ensured
through the manner of installation.
Installation instructions:
Must be observed for the cooker.
Work surface:
Level, horizontal, stable.
Preparing the units - Figure 1
Fitting unit:
Heat resistant to at least 90°C.
Cut-out:
Minimum distance to the side walls: 90 mm.
After the cutting out work is complete, remove the shavings.
Cut surfaces:
Seal with heat-resistant material.
Connecting the hob - Figs 2 and 3
The cooker must be connected to the mains, but switched off.
Put the
hob
down as shown in Fig. 2.
1.
Screw the hob's
PE conductor (green/yellow)
onto the cooker
earthing point
<
.
2.
Plug the
hotplate plug
into the cooker - see Fig. 3. The colour
of the cable must correspond to the colour shown on the label.
The lug
N
on the plug must point to the left.
Fitting the hob - Fig. 4
Cables:
Do not trap cables when fitting.
Push the hob in until it locks into place.
Tiled work surfaces:
Seal the tile joints with silicone rubber.
Insert the hob in the existing worktop cut-out with a depth of
500 mm - Figure 5
1.
Mark the centre of the cut-out
2.
Put the hob in place
3.
Align the markings on the hob surround and cut-out
4.
Press in the hob.
Removing the hob
Disconnect the appliance from the power supply.
Pull out the cooker a short distance. Unplug the cooking zone
plug. Finally, disconnect the
PE
conductor (green/yellow) from
the earthing screw.
Push out the hob from below.
Summary of Contents for E18M22N3
Page 2: ... ...
