11
Electrical connection
Electrical data:
Are to be found on the name plate inside the appli-
ance after removal of the filterframe.
Before undertaking any repairs,
always
disconnect the extractor hood from the electricity
supply.
Length of the connecting cable: 1.30 m.
This extractor hood corresponds to EC regulations
concerning RF interference suppression.
Installation
This extractor hood
is intended to be mounted
onto the kitchen wall.
1. Unhook the filter-holding Grid (see “Removing
and inserting metal self- supporting grease
filters”)
2. Draw a line on the wall from the ceiling to the
lower edge of the hood at the centre of the lo-
cation where the hood is going to be mounted.
3. Use the template or following the picture to
mark the points (
A-B-C
) on the wall where the
screws will be mounted.
����������������������
���
���
����������������
���
��
���
���
���
�����
�����
���
���
���
��
�
�
�
���
Ensure that the minimum distance between the
hob and the extractor hood is maintained –
400 mm
for the electric or gas hob.
4. Drill ø 12 mm holes
A
and ø 8 mm holes
B
for
the extractor hood. Drill ø 8 mm holes
C
for the
chimney brackets (only if you think to install the
chimney).
5. Insert bracket plugs
11a
into the holes
A
and
screw into place.
6. Insert plugs
11
into the holes
B
and
C
so that
they are flush with the wall.
7. Fix the brackets
7.2.1
using the
12a
screws
supplied (only if you think to install the chim-
ney).
In case of hood installation in recirculation
version with the chimney, the upper bracket
7.2.1 must be fixed together with the Air Outlet
Connection Support
7.3
.
Mounting the hood body
8. Adjust the two screws
Vr
, on brackets
11a
, to a
minimum.
9. Hook the hood canopy onto the two brackets
11a.
10. From inside the hood canopy, adjust the screws
Vr
to set the Hood Canopy level.
Installation
Note:
Take into account any special accessories
that are going to be fitted.
��
���
11. Tighten the safety screw
11
in holes
B
.
