NEFF D95FRW1S0, Instructions For Installation And Use Manual

Page: 10 / 24

en
Connecting to a hob
10
e
Connecting to a hob
Connectin g to a ho b
You can connect this appliance to a hob and then
control the functions of the hood via your hob.
Appliances can be connected to each other in different
ways:
Connecting appliances directly
If the appliance is connected directly to a hob, it cannot
be connected to your home network as well. The
appliance works like an extractor hood that is not
connected to the network and you can continue to
operate it via the control panel.
Connecting appliances via your home network
You can connect the appliance to the hob via your
home network and make use of the existing
infrastructure.
Notes
■
Make sure you follow the safety instructions in the
instruction manual for your extractor hood and that
these are complied with even when operating the
appliance via the hood controls on the hob.
■
Using the controls on the extractor hood always take
priority. It is not possible to use the hood controls on
the hob during this time.
Setting up a connection
The hood must be switched on before you can connect
the hob and extractor hood.
Make sure that the hob is switched on and is in search
mode.
Refer to your hob's instruction manual for more
information.
Connecting directly
1.
Press and hold the
#
and
˜
symbols at the same
time until the
D
and
Ù
indicators start flashing.
2.
Confirm the connection on the hob within the next
30 seconds.
The extractor hood has been connected to the hob
when the
D
stops flashing and stays permanently lit.
Connecting via your home network
Notes
■
You require a router that has WPS functionality.
■
You require access to your router.
■
The extractor hood cannot be switched on during the
connection process. You can cancel the process at
any time by pressing the
#
symbol.
1.
Press and hold the
#
and
˜
symbols at the same
time until the
D
and
Ù
indicators start flashing.
2.
Tap the + symbol to start automatic login on your
home network.
D
and
‚
will flash.
3.
Press the WPS button on the router within the next
2 minutes.
Once the connection to your home network has
been set up, the extractor hood will connect to the
hob automatically.
D
and
„
will flash.
The connection is process is complete when the
D
indicator stops flashing on the control panel and stays
permanently lit.
Note:
Connection will only be successful if both
appliances are connected to your home network and in
search mode. If the time allowed for search mode runs
out on one of the two appliances, start the search
again.
Resetting the connection
You can reset the connections you have saved on your
home network and on the hob at any time.
Press and hold the
#
and
‘
symbols at the same time
until a signal sounds.