12
Installation
This extractor hood
is intended to be
mounted onto the kitchen wall.
1.
Remove the grease filter (refer to
Operating Instructions).
2.
Draw a line on the wall from the ceiling
to the lower edge of the hood at the
centre of the location where the hood is
going to be mounted.
3.
Using the template, mark positions on
the wall for the screws.
Ensure that the minimum distance bet-
ween the hob and the extractor hood is
maintained –
550 mm
for an electric hob
and
650 mm
for a gas hob. The bottom
edge of the template equates to the lower
edge of the extractor hood.
4.
Drill 5 holes (dia. 8 mm) for the
extractor hood and 4 holes (dia. 8 mm)
for the brackets for fixing the flue ducts
and insert wall plugs flush with the wall.
Note:
Take into account any special
accessories that are going to be fitted.
5.
Screw on the 2 brackets for fixing the
upper and lower flue ducts.
6.
In order to help fix the hood onto the
wall, screw in the middle screw (without
a washer) until it protrudes by approx.
5 mm.
7.
Hook the extractor hood over the screw
in the wall
228
228
27
465
220
400
68
113
39
mind.
550 Elektro
650 Gas
5
ca. 5mm
Summary of Contents for D8002N0GB
Page 2: ...2 Abb 1 ELECTR Fig 1 GAZ mind 650 mind 550 ...
Page 14: ...14 Notes ...
Page 15: ...15 353121 1 2 1 Z5115X5 ...
