NEFF D46PU64X0, Instructions For Installation And Use Manual

Page: 6 / 20

en
Operating the appliance
6
1
Operating the appliance
Operating the appl iance
These instructions apply to several appliance variants. It
is possible that individual features are described which
do not apply to your appliance.
Note:
Switch on the extractor hood when you start
cooking and switch it off again several minutes after you
have finished cooking. This is the most effective way of
removing the kitchen fumes.
Control panel
Setting the fan
Switching on
■
Pull out the filter pull-out and touch the # symbol.
The fan will start at setting ƒ .
■
Touch the + or - symbol to alter the fan speed.
Note:
When the filter pull-out is pushed in, only fan
settings ‚ , ƒ and „ can be selected.
Switching off
Touch the
#
symbol. Slide in the filter pull-out.
Intensive setting
You can use the intensive setting if there is a large
build-up of odours and fumes/vapours.
Touch the
˜ symbol. ˜ƒ appears on the display. Touch
the - symbol to switch back to the ˜‚ intensive setting.
After approximately six minutes, the electronics
automatically reduce the fan to a lower setting . If you
want to end the intensive setting before the preset time
expires, touch the
˜
symbol.
Fan run-on time
Press - until the 9 symbol appears, or slide in the filter
pull-out.
After approximately 10 minutes, the fan will switch off
automatically.
Automatic mode
Switching on
■
Touch the
#
symbol.
The fan starts at setting
ƒ
.
■
Touch the
‘
symbol.
The optimum fan setting
‘‚
,
‘ƒ
or
‘„
is
automatically set via a sensor.
Switching off
Touch the
‘
or
#
symbol to switch automatic mode off.
The fan switches off automatically if the sensor no
longer detects a change in the air quality of the room.
Automatic mode can run for a maximum of four hours.
Sensor control
In automatic mode, a sensor in the extractor hood
detects the intensity of the cooking and roasting
odours. Depending on the sensor setting, the fan
automatically switches to another fan setting.
Default sensitivity setting:
†
Lowest sensitivity setting:
‹
Highest sensitivity setting:
Š
If the sensor control responds too quickly or too slowly,
it can be changed accordingly:
1.
Press and hold the
‘
symbol for approximately four
seconds when the fan is switched on. The setting is
displayed.
2.
The sensor control setting can be changed by
touching the + or - symbol.
3.
To confirm the entry, press and hold the
‘
symbol
for approximately four seconds.
AirFresh function
Touch the
3
symbol until the
‚ 3
appears. The
fan runs for approximately five minutes per hour.
Touch the
3 symbol if you want to end the AirFresh
function.
Explanation
#
Fan on/off
4
Noise reduction
3
AirFresh function
-
Reduces the fan settings
+ Increases the fan settings
˜
Intensive setting
‘
Automatic function
6
Light on/off/dimming