NEFF B57VS24N0B, Instruction Manual

Page: 32 / 60

en
Appliance door
32
Removing and installing the door panels
For cleaning, you can remove the glass panels from the
appliance door.
To do this, the appliance door must be removed
beforehand (see section "Removing and fitting the
appliance door").
:
Warning
Risk of injury!
The appliance must not be used again until the door
panels and appliance door have been correctly fitted.
Removal
Note:
Lay the removed glass panels on an even, soft
and clean surface.
1.
Remove the appliance door.
2.
Lay the appliance door with the front side facing
down on an even, soft and clean surface.
3.
Push on the left- and right-hand side on the outside
of the appliance door until the inner glass is
released on both sides (Fig.
!
).
4.
Carefully lift the inner glass and remove it in the
direction of the arrow (Fig.
"
).
5.
Push the intermediate panel downwards in the
‚
area, carefully lift the
ƒ
holder until it can be pulled
out (Fig.
#
).
6.
Lift the first and second intermediate panels from
below (Fig.
$
) and remove them in the direction of
the arrow (Fig.
%
).
7.
If required, remove the spacers (Fig.
&
) and seals
(Fig.
'
) for cleaning.
8.
Clean the door panels on both sides with glass
cleaner and a soft cloth.
:
Warning
Risk of injury!
Scratched glass in the appliance door may develop
into a crack. Do not use a glass scraper, or sharp or
abrasive cleaning aids or detergents.
9.
Dry and refit the door panels.
Installation
Note:
When fitting the door panels, ensure that they are
in the original order.
1.
Insert the intermediate glass so that the
‚
arrow is
facing upwards on the right-hand side (Fig.
!
).
2.
Check the fit of the four spacers and two seals on
the intermediate panel:
– Place the spacers centrally on each edge (Fig.
"
).
– Secure the seals at the corners (Fig.
#
).
2 1
E
D
1
D
2