Cleaning function
en
21
.
Cleaning function
Cleaning function
Your appliance is equipped with EcoClean and Base
clean. The EcoClean cleaning function is used to clean
the self-cleaning surfaces in the cooking compartment.
Use Base clean before starting EcoClean or for
intermediate cleaning of the cooking compartment floor.
Dirt is soaked beforehand using Base clean. It can then
be removed more easily.
EcoClean
The self-cleaning surfaces in the cooking compartment
are cleaned with the "EcoClean" operating mode.
The self-cleaning surfaces (back panel, ceiling panel
and side panels) are coated with a porous, matt
ceramic material. This coating absorbs and breaks
down splashes from baking, roasting and grilling while
the oven is in operation. If the surfaces no longer clean
themselves adequately and dark patches appear, the
surfaces can be cleaned by the cleaning function.
Cleaning recommendation
The appliance records how long it is in operation and
which operating mode is used. When cleaning is
recommended,
’–
will appear on the display when the
appliance is switched off.You can dismiss this message
by pressing any button except the
(
button. The prompt
will continue to be displayed, however, until the
cleaning function has been run in full.
Note:
You can completely reset the cleaning
recommendation counter by pressing and holding the
(
button for approximately 4 seconds.
The prompt will not reappear until the appliance has
been used a certain number of times again.
Caution!
If you do not act on this cleaning recommendation, the
self-cleaning surfaces in the cooking compartment may
become damaged.
If your appliance is already very dirty, e.g. because you
have used it to cook fatty poultry or roasts, or if you
notice dark patches on the self-cleaning surfaces, do
not delay running the cleaning function until this prompt
appears. The more often or the earlier the appliance is
cleaned, the longer the self-cleaning surfaces will retain
their ability to clean themselves. You can clean the
cooking compartment at any time as required using the
cleaning function.
Before running the cleaning function
Remove shelves, rails, accessories and ovenware from
the cooking compartment.
Cleaning the cooking compartment floor and the
inside of the appliance door
Remove the worst dirt from the cooking compartment
floor, the inside of the appliance door and the interior
lighting. Otherwise, patches will appear that can no
longer be removed.
Caution!
Do not use oven cleaner on the self-cleaning surfaces.
This will damage the surfaces. If oven cleaner does get
onto these surfaces, dab it off immediately using water
and a sponge cloth. Do not rub the surface and do not
use abrasive cleaning aids.
:
Warning – Risk of burns!
;
The appliance becomes very hot on the outside
during the cleaning function. Never touch the appliance
door. Allow the appliance to cool down. Keep children
at a safe distance.
Setting the cleaning function
Make sure you follow all the preparation instructions
before setting the cleaning function.
The cleaning function is preset to run for 1 hour. This
duration cannot be changed.
1.
Use the function selector to set the cleaning
functions
2
.
The
2
symbol and the cleaning functions will
appear on the display.The first cleaning function is
highlighted.
2.
Press the
)
or
(
button repeatedly until the
™
symbol
is highlighted.
“ECO” will appear on the display.
3.
Turn the temperature selector.
"On" will appear on the display.
The cleaning function will start after a few seconds. The
duration will count down on the display.
Ventilate the kitchen while the cleaning function is
running.
Once the cleaning function has run through to the end,
an audible signal will sound. To switch off, turn the
function selector back to the "Off" position.
Once the cleaning function has finished
Once the cooking compartment has cooled down, wipe
down the cooking compartment with a damp cloth if
necessary.
Note:
During operation and while the cleaning function
is active, reddish patches may form on the surfaces.
This is not rust, but residue from food. These spots are
not harmful and do not impair the cleaning ability of the
self-cleaning surfaces.
Base clean
Base clean makes it easier to clean the cooking
compartment floor. Dirt is soaked beforehand by
vaporising the soapy water. It can then be removed
more easily.
:
Warning – Risk of scalding!
Water in a hot cooking compartment may create hot
steam. Never pour water into the cooking compartment
when the cooking compartment is hot.
Summary of Contents for B4ACM5HH0B
Page 1: ...en INSTRUCTION MANUAL BUILT IN OVEN B4ACM5HH0B...
Page 2: ......
