Rails
en
31
For reasons of hygiene, the descaling programme must
be run in full.
If descaling is interrupted, you can no longer set any
operation. To ensure that the appliance is ready for op-
eration again, carry out two rinse cycles.
Preparing descaling
ATTENTION!
The length of time for which the descaler is left to work
is based on the recommended, liquid descaler. Other
descalers may damage the appliance.
▶
Only use the liquid descaler recommended by us
for the descaling programme.
If descaling solution comes into contact with the control
panel or other delicate surfaces, it will damage them.
▶
Remove descaling solution immediately with water.
1.
Mix the descaling solution:
‒
200 ml liquid descaler
‒
400 ml water
2.
Open the control panel.
3.
Remove the water tank and pour the descaling solu-
tion into it.
4.
Once the descaling solution has been poured into
the water tank, slide the tank back in.
5.
Close the control panel.
Setting the descaling process
ATTENTION!
If descaling solution comes into contact with the control
panel or other delicate surfaces, it will damage them.
▶
Remove descaling solution immediately with water.
Requirement:
The appliance must be prepared for de-
1.
Press to switch the appliance on.
2.
Press .
3.
Swipe left or right to set "Descale" .
4.
Press the bottom row.
a
The duration will appear on the display. You cannot
change the duration of the descaling process.
5.
Press the bottom row.
6.
Press to start the descaling process.
a
The descaling process will start. The duration will
count down on the display.
a
Once the descaling process has run through to the
end, an audible signal will sound.
Running the first rinse cycle
1.
Open the control panel and remove the water tank.
2.
Thoroughly rinse the water tank and fill it with fresh
water.
3.
Slide in the water tank and close the control panel.
4.
Press to start the rinse cycle.
a
The rinse cycle will start. The duration will count
down on the display.
a
Once the rinse cycle has run through to the end, an
audible signal will sound.
Running the second rinse cycle
1.
Open the control panel and remove the water tank.
2.
Thoroughly rinse the water tank and fill it with fresh
water.
3.
Slide in the water tank and close the control panel.
4.
Press to start the rinse cycle.
a
The rinse cycle will start. The duration will count
down on the display.
a
Once the rinse cycle has run through to the end, an
audible signal will sound.
5.
Empty and dry the water tank.
→
"Emptying the water tank", Page 17
20 Rails
To thoroughly clean the rails and the cooking compart-
ment, or to replace the rails, you can remove the rails.
20.1 Changing the shelf position for the
telescopic shelf
The bars and telescopic shelves can be positioned in
any order.
For example, you can fit the telescopic shelf to the
shelf position which you use the most frequently.
Removing the bar
Note:
Telescopic shelves are removed and fitted like
bars.
1.
Push the bar towards the rear until it can be
pulled out upwards .
2.
Unhook the bar at the rear and remove it.
