6
Switching on the product
•
Plug the power cable
A
e
into the power outlet.
4
The product switches on automatically.
4
Set the time within one minute after powering
by adjusting the values and confirming.
1. Press
A
9
to switch to FM mode.
2. Turn
A
5
to adjust the volume.
3. Press
A
4
or
A
r
to adjust the FM frequency
manually.
Entering standby mode
4
In standby mode the display will switch off
automatically between 23:00 and 4:59. Press
A
9
to switch on the display for 5 seconds.
•
Press
A
9
to switch the radio to standby mode.
•
Press
A
9
again to switch off standby mode.
Setting the time and alarm
1. Switch the product to standby mode.
2. Press and hold
A
2
.
4
12H or 24H shows on the display.
3. Select one and confirm.
4. Set the current hours and confirm.
5. Set the current minutes and confirm.
4
The alarm icon shows on the display and the
hour digits will start to flash.
6. Set the hours for your alarm and confirm.
7. Set the minutes for your alarm and confirm.
4
BUZZ shows on the display.
8. Select BUZZ for a buzzer or TUNE for radio as
alarm and confirm.
4
U shows on the display when choosing TUNE.
9. Adjust the volume with
A
4
/
A
r
and confirm.
Switching the alarm on/off
1. Press
A
2
to switch the alarm function on or off.
4
An alarm icon shows on the display when the
alarm is on.
4
When the alarm goes off, press
A
9
to switch
off the alarm.
Saving radio presets
1. Press and hold
A
4
or
A
r
to search for a station
automatically.
2. Press and hold
A
2
until the frequency starts to
change to save stations automatically.
•
Do not put hands and foreign objects inside the
product.
•
Keep the product away from magnetic or
magnetized objects.
•
To prevent possible hearing damage, do not listen
at high volume levels for long periods.
•
Do not use any accessories that are not included.
•
Do not install the product under a cupboard with a
lighting strip installed underneath.
•
Do not install the product above places where
steam and water can get in contact with the
product.
•
Do not use aggressive chemical cleaning agents
such as ammonia, acid or acetone when cleaning
the product.
•
Do not open the product.
Inserting the batteries
(image
B
)
1. Open the battery compartment
A
t
.
2. Insert 2 AA batteries (not included).
-
Make sure to match the (+) and (-) polarity
markings.
3. Close
A
t
.
Installing the product under
cupboard
(image
C
)
4
The cupboard floor thickness should be at least
8 mm.
4
Install the product close to a power outlet.
4
Use a screwdriver to fix the screws.
4
Use the optional feet for thin cabinet floors.
-
Do not plug the power cable into the power
outlet during the installation.
-
Do not use any accessories that are not included.
-
Do not install the product under a cupboard
with a lighting strip installed underneath.
-
Do not install the product above places where
steam and water can get in contact with the
product.
Controlling the product
•
Press the up button
A
4
or down button
A
r
to
adjust values.
•
Press the program button
A
2
to confirm the
selected value.
