Nederman FlexPAK Standard, Installation And Service Manual

Page: 24 / 34

FlexPAK
6.8 Loading new software
NOTE!
• This section is only for Nederman qualified
service technicians. Only Nederman qualified
service technicians may make changes to, or
install new software.
• Make notes of actual parameter settings.
6.8.1 Frequency converter control panel
To change the software or install new software for
the unit, the parameters in the frequency converter
have to be changed by means of the frequency con-
verter control panel available from Nederman.
6.8.2 Firmware and software labelling
NOTE!
• The software version is found on a label
taped to the front of the PLC. LOGO 8 soft-
ware is updated using an SD Card. Follow the
included instructions when the software
needs to be updated.
• To find the firmware and software revision
number in the PLC display, see Figure 8 , item
1. Pressing ‘OK’ when the PLC displays this
menu will show this information. See also the
PLC Settings Manual.
The firmware and software revision can be read in the
PLC and also on the label on the PLC.
The number, 2155264-2-EN for example, consists of
the following parts:
• 2155624 = The software number.
• 2 = The revision.
• EN = The language of the display text.
6.8.3 Upgrading the system
LOGO 8 software is updated using an SD Card. Care-
fully follow the included instructions when the soft-
ware needs to be updated.
24