10
www.nedaplibrary.com
Reader
The reader itself can also be placed on top of a table, or can be mounted under a table, or against a
wall. The reader is mounted using three screws. Always make sure that none of the cables is under
any stress when mounting the reader.
On table
Get the rubber feet from the packaging, and place these under the reader casing to make sure it will
not scratch the surface that it will be placed upon.
Below table or on wall
The reader can also be mounted under a table, or against a wall. This can be done using 3 screws,
supplied with the reader.
Predrill the three holes in the surface. The pattern for these holes can be found in the drawing
T5760925-40.01.
Place the top two screws, and screw them in so that the head of the screw is only 1 or 2 mm out of
the surface. Remove the hood of the MidRanger by levering a screwdriver carefully in the opening at
the front of the reader. Slide the MidRanger onto the two screws, and place the third and final screw.
Snap the hood back onto the reader.
