MACE | QUICK REFERENCE GUIDE
Installation
2/5
1
INSTALLATION
SAFETY INSTRUCTIONS
The following safety precautions should be observed during normal use, service and repair:
The MACE may only be installed and serviced by qualified service personnel.
Disconnect the power supply before (dis)connecting any wires, MACE is NOT hot-swappable, so when making or
changing connections, power must be switched off.
The cable shield shall be connected with safety ground and the metal case of the external device(s).
To be sure of safety, do not modify or add anything to the MACE other than mentioned in this installation guide or
indicated by NEDAP N.V.
MOUNTING INSTRUCTIONS
The MACE can be mounted to any surface, including directly to metal. See the picture below for details about the
dimensions.
Figure
1
: MACE dimensions (mm)
Mount the base-plate on the required location:
1
Ensure that it is placed correctly covering the cable entry hole.
2
Properly fix the base-plate into its position using the 2 screws. When mounting on a stone or concrete wall
drill 5mm holes for the plugs. When mounting on wood, drill with 2.5mm.
Install the MACE reader onto the base-plate:
3
Feed the cable through the cable entry hole. Important note: minimum bending radius 30mm.
4
Attach the top of the MACE onto the base-plate.
5
Fix the assembly using the screw on the bottom.
