NED XCM6040SAT2, User Manual

Page: 27 / 81

NED
UME-0027-03 XCM6040SAT2
27
Multi-slope time setting mst 0 to 511 0 to 511 0 to 511
Set the timing aspect of the
vertex of the multi-slope function
VAL1<=VAL2<=VAL3 i.e. when
using 4 slopes, select values
such that VAL2/VAL1 and
VAL3/VAL2 work out to the same
result. Moreover, the result
should be less than 10.
Programmable Exposure Time
＝
VAL2
÷
{26666667
÷
(16
ｘ
2
＾
VAL1)}
Exposure-Readout Time
＝
VAL1
÷
{26666667
÷
(16
ｘ
2
＾
VAL1*)} The VAL1* is VAL1
of Programmable Exposure Time item.
4.1.5 Memory Setup Values (Factory Settings)
The memory setup values (factory settings) are shown below.
Table 4-1-5-1 Memory Setup Values (Factory Settings)
Control Item
CMD VAL1 VAL2 VAL3
Control Description
Analog Gain gax 0 x1(0dB)
Digital Gain gdx 0 x1
Digital Offset odx 0
0DN
(8bit)
Exposure Mode inm 0 Free Run
Programmable Exposure
Time
int 1 61
73.2
μs
(Dividing=1
、
Counter=61)
Output Signal Setting 1
voa 0 0 8bit, 6144pixels
Output Signal Setting 2 voc 0 Linear
Test Pattern tpn 0 OFF
Pixel Correction Setting shc 1 900
Factory White Correction
Correction Level 900DN (10bit)
Operation Status Readout pad 0 0
μs
Scanning Direction rev 0 Forward
：
0
Multi-slope signal setting msl 0 5 10 3 Slope settings
Multi-slope time setting mst 0 1 10 3 Slope settings