The heater comes with a 250 (d) x 325 (w) x 6 (h) mm baffle
plate. This rests on the two lugs welded to the inside front of
the firebox and on the brick retainer at the back of the
heater.
Position the baffle plate vertically towards the rear of the
firebox with the 100mm strip welded to the baffle at the top
facing forward. Bring the top edge towards the front of the
heater so that it slides up and over the two support lugs with
the 100mm strip located between them. Raise the lower rear
edge of the baffle plate to rest on top of the brick retainer.
With the baffle plate it it’s correct position, ensure it is
pushed all the way back so that it doesn’t fall.
A stainless steel rod with a thread at one end and black knob
on the other will have been supplied in the heater. Pass the
threaded end of the rod through the hole near the top front
corner on the left side of the heater. Push the rod through
until one can feel it has located the nut on the air slide, then
screw rod until tight. Check that the rod slides freely back and
forth.
Front view:-
Front view:-
Top view showing position of flue spigot:-
10. TECHNICAL DRAWINGS
8. INSTALLING BAFFLE PLATE
9. INSTALLING TOP AIR CONROL ROD
