www.nectogroup.com
USER MANUAL 2AMCV551VPBS
In order to activate this mode of control/operation it is necessary connect the DALI bus between the DALI
terminals and an N.O. PUSH button to PUSH terminals according to Figure 1 (DC voltage range:10÷265V, AC
12÷265Vac 50÷65Hz).
No polarization is needed for the input signal.
The maximum current absorbed by the PUSH interface is about 2mA.
PUSH input drive the intensity.
The dimmer saves the output position in order to restore the set level in case of power failure (preset).
PUSH interface operation
Single Click (rapid press (<1sec))
- Turns on or off the output (ON/OFF).
Double Click (rapid press (<1sec))
- Sets maximum brightness (output= 100%)
Long Press (long press (>1sec))
- If the dimmer is in OFF position, it sets the output to the minimum value (default= 1%)
- If the dimmer is in ON position, the long press enables the output dimming (up/down).
The maximum current absorbed by the PUSH interface is about 2mA.
PUSH + BLUETOOTH MODE
pag|5
