NEC Xen Master, Programming Manual

Page: 177 / 536

Automated Attendant Message Access Code (1-Digit) Assignment 1 - 159
Programming Manual May 2003
A6-
324000-6
42-02 -
Release 6.0
May 2003
1-4-14
System Mode
1
Submode
4
Data No.
14
PC Programming
a
+ AU
Automated Attendant Message
Access Code (1-Digit) Assignment
General Description
Use this Memory Block to enter a 1-digit code to route an incoming call from the Automated
Attendant.
Display
Programming Procedures
1 Go off-line.
2 Press LK1 + LK4 +
AD
to access the Memory Block.
3 Use the dial pad to enter data.
Note: Use the following to enter data:
A ~ H to enter Automated Attendant message number
K ~ I to enter dial number
Setting Data Allowed
Function Code001~053 sec.
Note: 000 is unused.
Default Values
4 Press
N
to write the data and advance to the next dial number then to each Automated Attendant number.
5 After all data is entered, press
N
to write the data.
6 Press
P
to go back on-line.
Related Programming
M.B. Number Memory Block Name
Refer to Chapter 2 Guide to Feature Programming
N
1. Function 011 (Bypass Automated Attendant) uses Memory Blocks 4-01 CO/PBX Ring Assignment (Day Mode) and
4-02 CO/PBX Ring Assignment (Night Mode) to ring according to those assignments.
2. If a caller receives a busy signal after being transferred by the Automated Attendant, the following Fixed Access
Codes apply:
A
Step Call
J Receive a second dial tone
L CO rings based on Day/Night Ring Assignment
1 4 : A A A C 1 = 0 = 0 3 0
T I M E D I S P L A Y
Data
No. Title
Setting
Data
A.A. Msg.
No.
1~8
Dial No.
0~9
Dial
Number
Function
Code
Contents
9 030 Specified Station
Call (0)
1 010 Station Number
2 010 Station Number
3 010 Station Number
0,4 ~ 8 000 Unregistered