NEC XEN IPK DIGITAL TELEPHONE, Programming Manual, Page: 501 / 638

5-00, Digit Add/Del for Tie Line Networking
DRAFT 3
Chapter 1 – 481
Xen IPK Programming Manual
Doc. No
.: 8194 -
Rele
ase 2.
0
December
2004
5-00
System Mode
5
Submode
—
Data No.
00
PC Programming
+ ALN
Digit Add/Del for Tie Line
Networking
General Description
Use this Memory Block to specify the number of digits to be added to and/or deleted from the
telephone number sent from a distant system over Tie lines or from DID lines. The digits enable
the system to determine whether a call is directed to itself (local) or to another system (distant).
Refer to the Notes.
Display
Programming Procedures
1 Go off-line.
2 Press LK5 +
N
+ KK to access the Memory Block.
3 Press the corresponding CO/PBX line key to enter the data.
Note: Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K ~ I to enter numeric data
R
to go to the next Trunk Group No.
Setting Data:
000 : No Addition or Deletion
001~009 : [1]~[9] Addition
010 : [0] Digit Addition
100~199 : [00]~[99} Addition
201 : 1 Digit Deletion
202 : 2 Digit Deletion
301~309 : 1 digit Delete and 1~9 Add
310 : 1 digit Delete and 0 Add
400~499 : 1 digit Delete and 00~99 Add
501~509 : 2 digit Delete and 1 ~ 9 Add
510 : 2 digit Delete and 0 Add
600~699 : 2 digit Delete and 00 ~99 Add
4
After entering all data for all pages, press
N
to write the data.
5
Press
P
to go back on-line.
0 1 / 0 0 : A D D / D E L 0 0 0
T I M E D I S P L A Y
Trunk
Group
No.(01~32)
Data
No. Title
Setting
Data