NEC XEN IPK DIGITAL TELEPHONE, Programming Manual, Page: 485 / 638

4-59, APR Hookflash Selection
DRAFT 3
Chapter 1 – 465
Xen IPK Programming Manual
Doc. No
.: 8194 -
Rele
ase 2.
0
December
2004
4-59
System Mode
4
Submode
—
Data No.
59
PC Programming
+ BTM
APR Hookflash Selection
General Description
Use this Memory Block to allow/deny Hookflash for an Analogue Port Adapter (APR) on a
Multiline Terminal.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
NO YS
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1 Go off-line.
2 Press LK4 +
EI
to access the Memory Block.
3 Use the following to enter data:
J to move the cursor left
L
to move the cursor right
K ~ I to enter numeric data or Tel Port No.
– OR –
R
to go to next assigned Tel Port No.
Q
+1 to enter A for Port Numbers 100~109
Q
+2 to enter B for Port Numbers 110~119
Q
+3 to enter C for Port Number 120
4 Press the corresponding CO/PBX line key to change the setting data option.
5 Press
N
to write the data and display Memory Block 4-1 for next Tel Port No.
6 Program the next Tel Port No. or press
P
To go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-02 Hookflash Time Selection
1-3-02 SLT Hookflash Signal Selection
4-40 APR Ring Mode Assignment
4-93 DTMF/DP SLT Type Selection
N
Operation of SLT connected to APR is the same as the Single Line Telephone.
0 1 / 5 9 : H K F L S H N O
T I M E D I S P L A Y
Tel Port
No.
(01~CO)
Data
No. Title
Setting
Data