4-18, Station Name Assignment
DRAFT 3
Chapter 1 – 425
Xen IPK
Programming Manual
Doc. No
.: 8194 -
Rele
ase 2.
0
December
2004
System Mode
4
Submode
—
Data No.
18
PC Programming
+ BTT
Station Name Assignment
General Description
Use this Memory Block to assign names for telephone stations.
Display
Programming Procedures
1
Go off-line.
2
Press LK4 +
A
H
to access the Memory Block.
3
Use the dial pad to enter data. Refer to
Section 7, Character Code Tables
, and
enter the 3-digit code to display each character.
Note:
Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K
~
I
to enter numeric data
U
to clear all data when cursor is at setting data position
R
to go to next Tel Port No.
Default Values
Not Specified
4
Press
N
to write the data.
5
After entering all data, press
N
6
Press
P
to go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
1. While an internal line is ringing or in use, the station number and name of the other party are displayed.
2. The name is not displayed when Tone Override, Automatic Callback, or Callback Request is displayed
3. Only 6 digits/characters can be used for each name.
4. Telephone ports A0~C0 are ports 100~120.
0 1 / 1 8 : <
>
T I M E
D I S P L A Y
Data
No.
Tel Port
No.
(01~99)
A0~C0
Setting
Data
