NEC XEN IPK DIGITAL TELEPHONE, Programming Manual, Page: 444 / 638

424 – Chapter 1
DRAFT 3
Station to Class of Service Feature Assignment, 4-17
December 2004 NEC Business Solutions Ltd
Doc.
No.: 8194 -
Release 2.0
Dece
mber 2004
4-17
System Mode
4
Submode
—
Data No.
17
PC Programming
+ BTT
Station to Class of Service
Feature Assignment
General Description
Use this Memory Block to specify, per station, a class for each Table (1 and 2) to enable/
disable features.
Display
Programming Procedures
1 Go off-line.
2 Press LK4 +
A G
to access the Memory Block.
3
Use the dial pad to enter Service Class (00 ~ 15) for Table 1.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K
~
I
for entering data
Default Values
4 Press
N
to write the data and display Table 2 data.
5 Enter Table 2 Service Class, and press
N
again.
6 Press
P
to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-8-07 Class of Service (Attendant) Feature Selection 1
1-8-08 Class of Service (Station) Feature Selection 2
N
1. Table 1 includes features that telephone ports 01 and 02 users are normally allowed to activate. Select any Class
pattern specified in Memory Block , 1-8-07 , Class of Service (Attendant) Feature Selection 1.
2. Table 2 includes features that all telephones users are normally allowed to activate. Select any Class pattern specified
in Memory Block , 1-8-08 , Class of Service (Station) Feature Selection 2.
3. Telephone ports A0~C0 are ports 100~120.
0 1 / 1 7 : C L S ( 1 ) = 0 0
T I M E D I S P L A Y
Data
No.
Tel Port
No.
(01~99)
A0~C0
Setting Service
Class Title
Table No.
1/2
Tel. No. Table No. Svc. Class
01
1 ATTN 00
2 STA 00
02
1 ATTN 00
2 STA 00
03 ~ C0
1 ATTN 15
2 STA 00