NEC XEN IPK DIGITAL TELEPHONE, Programming Manual

Page: 258 / 638

238 – Chapter 1
DRAFT 3
PC Programming Password Assignment, 1-8-17
December 2004 NEC Business Solutions Ltd
Doc.
No.: 8194 -
Release 2.0
Dece
mber 2004
1-8-17
System Mode
1
Submode
8
Data No.
17
PC Programming
+ CSP
PC Programming Password
Assignment
General Description
Use this Memory Block to assign system passwords that must be entered when connecting to
the system using MAT PC Programming.
Display
Programming Procedures
1 Go off-line.
2 Press LK1 + LK8 + AG to access the Memory Block.
3 Use the following to enter Class 1(Technician Mode) and password (8 digits max).
Note: Use the following to enter data:
K
~
I
to enter numeric data
Press
U
to clear data
Default Values
Class 1, 2 All Blank
4 Press
N
to write the data and advance to Class 2 (End User Mode).
5 After entering Class 2 password, press
N
to write the data. The next Memory Block is displayed.
6 Program the next Memory Block or press
P
to go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
1. Password 1 (Class 1) is used for Technician MAT PC Programming
2. Password 2 (Class 2) is used for End User MAT PC Programming.
3. Password 1 (Class 1) can be assigned only by telephone programming. It cannot be assigned or changed by
Technician or End User MAT PC Programming.
4. Password 2 (Class 2) can be assigned by telephone programming or Technician MAT PC Programming. It cannot be
assigned or changed by End User MAT PC Programming.
5. Password 2 (Class 2) cannot be assigned until password 1 (Class 1) is assigned in the Memory Block.
6. For passwords for both classes; only the first 5 digits are used.
1 7 : ( 1 ) =
T I M E D I S P L A Y
Data
No.
Setting
Data
Class
No. 1