======================================================================
Control Commands for NEC Projector (Basic) Rev 3.0.30f
Copyright (C) NEC Viewtechnology, Ltd. 2002-2006
----------------------------------------------------------------------
Updated on November 09, 2007
----------------------------------------------------------------------
This file contains information about NEC projector control commands.
Model
Name
GT60 :
GT5000/GT6000 Series
HT :
HT1000/HT1100 Series
HT10 :
HT410/HT510 Series
LT :
LT180
LT30 :
LT25/LT30/LT35 Series
NP40 :
NP40/NP50/NP60 Series
LT60 :
LT220/LT240/LT240K/LT260/LT260K/LT245/LT265 Series
LT80 :
LT280/LT380 Series
MT70 :
MT860/MT1060/MT1065/MT1075 Series
NP1000 :
NP1000/NP2000/NP1150/NP2150/NP3150 Series
WT :
WT600/WT610/WT615 Series
VT :
VT770 Series
VT70 :
VT37/VT47/VT480/VT57/VT570/VT575/VT670/VT676 Series
VT80 :
VT48/VT480/VT580 Series
VT90 :
VT49/VT490/VT590/VT595/VT695/VT700 Series
NP4000 :
NP4000/NP4001 Series
======================================================================
Contents
1. Projector Control
2. Connection Method
3. Interface Conditions
4. List of Commands
5. Command Descriptions
6. Table of Response Error Codes
======================================================================
1. Projector Control
----------------------------------------------------------------------
NEC projectors make use of control commands that control the functions of the projector via connection with
a personal computer or another device.
======================================================================
2. Connection Method
----------------------------------------------------------------------
The following 3 kinds of connection methods are available for sending and receiving control commands.
1. Serial connection using the serial port on the projector
A serial cable is required.
