6.2.2 GUI software WriteEZ1 for Flash Programming
The GUI software WriteEZ1 for flash programming is required to program the
Nodes with the Sample Programs. To install the WriteEZ1, select the “setup.exe”
program that can be found in the following directory in the CDROM provided:
<CD>\NEC Tools 32\WriteEZ1. The setup dialogues will guide you through the
installation process.
You will also need to install the USB driver required to emulate the UART
communication (which is the only one supported for the flash programming
interface) by the USB communication. Details about the installation procedure can
be found in the section
6.2.3 Sample Program Installation
To install the sample/demonstration program for the
V850 ZigBee
TM
Gateway
Development Platform
board, select the SETUP program in the directory <CD>
\SamplePrograms\ of the CDROM. The setup dialogue will guide you through the
installation process.
6.3 USB Driver Installation
In order to use the
V850 ZigBee
TM
Gateway Development Platform
board for On-
Chip debugging or FLASH programming, the USB driver needs to be installed on
the host machine. Two different drivers need to be installed:
-
the USB serial converter
-
the USB serial port
Install the drivers according to the following procedure:
•
Installation on Windows 2000
•
Installation on Windows XP
6.3.1 Installation on Windows XP
When the
V850 ZigBee™ PRO Gateway Development Platform
board is
connected with the host machine, the board is recognized by Plug and Play, and
the wizard for finding new hardware is started. Check that "Install from a list or
specific ..." is selected, then click Next >.
V850 ZigBee Gateway Development Platform, Installation
and Operation
Chapter 6
User's Manual U19026EE3V0UM00
37
