NEC UX5000, Manual

Page: 492 / 588

Customize
System Options: [Timer]
474
◆
Chapter 3: Programming UX Mail Manual
[Timers]
After Last Protocol Digit
After a voice mail port receives an entire protocol string from the UX5000, this option determines how long
voice mail will wait between the last digit of the string and the receipt of the hangup string.
Options
● 0-99 seconds
Default
✔
1 second
[Timers]
Silence Limit for Recording
Use this timer to set the length of the pause (silence) allowed when a caller is leaving a message or a Sub-
scriber or Guest Mailbox user is recording a message. If the silence is longer than this interval, the caller
hears, “
Recording has been paused due to silence.”
● See
R
ECORDING
S
ILENCE
E
LIMINATION
(
PAGE
265)
for more.
Options
●
1-999 seconds
Default
✔
5 seconds
[Timers]
Message Backup/Go Ahead Time
Use this timer to set the backup/go ahead interval. This interval sets how far voice mail backs up when a user
dials
B while recording or listening to a message. This interval also sets how far voice mail jumps ahead
when a user dials G while listening to a message.
● See
L
ISTENING TO
M
ESSAGES
(
PAGE
173)
.
● See
M
ESSAGE
R
ECORD
(
PAGE
220)
.
Options
● 1-60 seconds
Default
✔
5 seconds
[Timers]:
Page/Meet-me Page Hold Timer
This option is not used.
[Timers]
Flash Timer
Use this timer to set the duration of the voice mail port flash (open loop) that occurs when a dial string or
option contains a Flash (
F ) command. You should only change this option if the Flash command causes
inadvertent disconnects from the UX5000 or outside line.
Options
● 1-999 in 10 mS increments (1 = 10 mS)
Default
✔
50 (500 mS)
This timer is automatically set during installation. You
should not change this entry from its default setting.