(0913104)
February 6, 2009
Printed in U.S.A.
NEC Uni
fi
ed Solutions, Inc.
4 Forest Parkway, Shelton, CT 06484
TEL: 203-926-5400 FAX: 203-929-0535
www.necux5000.com
4.
The LCD screen will display
Initialize
.
5.
After 2 to 3 seconds release keys
4
and
6
at the same time and the Terminal Con
fi
guration Menu
Service Class R/W Mode
will open.
6.
Press key
0
to select
Data Initialize
.
7.
The terminal will show “
Saving…
” and return to the home menu.
8.
Press key
1
“Line Key Type” to reset the terminal line key con
fi
guration.
9.
Press the key
#
(3, 4, or 5) that corresponds to the number of available line keys on the terminal that you are con
fi
guring.
(Example: 24 Line Key terminal press key 5).
8-button
Key 3
12-button
Key 4
24-button
Key 5
10. Press
Line Key 2
to save this value and you will be returned to the home menu
Service Class R/W Mode
.
11. At
Service Class R/W Mode
home menu, press key
2
to set the Key Kit type that is installed on your terminal.
12. Press key
0
and key
3
.
13. Press
Line Key 2
to save this value and you will be returned to the home menu
Service Class R/W Mode.
14. Press key
8
“FDS Mode Set” to verify terminal setting.
15. Press key
2
for FDS = ON.
16. Press
Line Key 2
to save this value and you will be returned to the home menu
Service Class R/W Mode
.
17. At
Service Class R/W Mode
home menu, press key
3
to set the USA 508 Settings.
18. Press key
2
to turn “ON” USA 508.
19. Press
Line Key 2
to save this value and you will be returned to the home menu
Service Class R/W Mode
.
20. Verify that all the proper settings have been saved. Press
*
and use the cursor to scroll up and down to make sure that the
proper values are set.
21. Press the
CHECK
Soft Key to return to the top of the menu and use the handset to go off hook and then back on hook to
reset the terminal with your new settings.
NOTE 1: DO NOT change any other values as this will affect the audio balance and performance of the terminal.
NOTE 2: Updated values will be saved even after terminal reboot.
NOTE 3: The Enhanced Digital Terminals must perform Acoustic Training after any parameter change. This
Acoustic Training will automatically start during the
fi
rst call after these settings have been changed. NEC
recommends that a test call with conversation be placed for one minute to allow for the terminal to adjust for
the new settings.
