UNIVERGE UM8500 I
NTEGRATION
G
UIDE
114
Programming
the phone
system
If programming options other than those supplied in the following procedures are
used, the integration’s performance can be affected.
To program the IP voice messaging ports in the phone
system
1
Make sure that the NEAX 2000 phone system has licenses for using IP
extensions using command F88>12>.
2
Configure the voice messaging ports as IP Terminal extensions, the default IP
extensions type.
3
Write down the MWI analog codes that the NEAX 2000 phone system uses for
turning the phones lamps on and off. These codes are needed when
configuring UM8500 to work with the integration.
4
Make sure that the following service features are enabled in the phone
system:
■
Call hold
■
Assignment of no answer timer for blind transfer to station or blind
transfer attendant
■
Blind transfer
5
Assign all of the voice messaging ports to a Uniform Call Distribution (UCD)
group, use commands CM 17 Y=0 /1 /2.
6
Set the same location ID for all voice messaging ports and set either or both of
the codecs G711, U-Law or A-Law, and G729A with payload size equal to 40
milliseconds for that location ID using commands CM12 YY=39, CM67 YY=00,
and CM42 YY=100 ~ 177.
NOTE
The following procedures are written with the assumption that you
will use a Customer Administration Terminal (CAT) or Maintenance
Administration Terminal (MAT) to program the phone system.
NOTE
The NEAX 2000 phone system may not have any settings to use
codes for MWI analog operations. If this is the case, use command
CM 20 Y = 0/1/2/3 > set code > A040, CM 20 Y = 0/1/2/3 >
cancel code > A041, CM 13 Y = 03 > station > 0 - for providing
each station with Message Waiting capability.
Summary of Contents for UNIVERGE UM8500
