NEC Univerge SV9100, System Hardware Manual

Page: 84 / 556

Issue 2.0
2-12 SV9100 System Specifications
3.3 Blade Capacities
This is determined by the maximum blade configuration allowed. When installing
single line sets, DISA, or tie lines, CPU circuits must be allocated for DTMF
receivers. To install single line sets with CO/PBX line access, or when installing
immediate-start tie lines, CPU circuits must be allocated for dial tone detection.
Table 2-6 SV9100 Maximum 9.5” Gateway and 19” System Capacities – Blades
Hardware
9.5”
Chassis
19”
Chassis
with CPU
19”
Chassis
without
CPU
19”
Chassis
x4
Networked
Chassis
(NetLink)
Comments
Number of Slot(s) for Interface
Package
3 Slots 5 Slots 6 Slots 23 Slots
Common Control Blades:
GCD-CP10 1 1 0 1 50 –
GPZ-IPLE
(VoIP Daughter Board)
1 1 0 1 50 This unit provides
256 VOIP Gateway
channels
Station Blades:
GCD-4DIOPB
(4 DID/OPX) 2 5 6 23 128 When installed as
an OPX blade
GCD-8DLCA
(8 Digital Station Interface) 2 5 6 23 112 –
GCD-16DLCA
(16 Digital Station Interface) 2 5 6 23 56 –
GPZ-8DLCB
(8 Digital Station Interface
Daughter Board) 2 5 6 23 56 –
GCD-4LCF
(4 Single Line Telephone Interface) 2 5 6 23 224
GCD-8LCF
(8 Single Line Telephone Interface) 2 5 6 23 112
GPZ-4LCF
(4 Single Line Telephone Interface
Daughter Board) 2 5 6 23 74
GPZ-8LCF
(8 Single Line Telephone Interface
Daughter Board) 2 5 6 23 56
GCD-LTA

(8 Digital/2 Single Line)
2 2 2 8 23 An optional GPZ-
4COT( ) or
GPZ-2BRIA can be
installed