NEC Univerge SV9100, General Description Manual

Page: 174 / 190

Issue 2.0
5-18 Hardware Specifications

512 virtual extensions

Connection for GPZ-IPLE VoIP Daughter Board

Connection for Voice Mail SD Card
(
SD-A1
/
SD-B1
)

Supports TAPI 1.x

One Green Status LED

Four Red Status LEDs

Five diagnostic LEDs which indicate the status of various system functions

During normal operation, the RUN LED is flashing and the remaining LEDs are off.

700x700 Time Division Multiplex Switch (TDM Switch)

Digital Phase Locked Loop (DPLL)
S
ECTION
4 C
ABLING
R
EQUIREMENTS AND
S
PECIFICATIONS
This section provides cabling requirements and specifications for various equipment
used in the SV9100 system.
Figure 5-4 Connecting the DLC Using Twisted 2-Pair Cable is a diagram of the
chassis connected with each of the multiline terminals and single line telephones by
a separate twisted 1-pair cable or 2-pair cable (only for multiline terminals).
Refer to the following tables for cabling requirements and specifications.

Table 5-15 DT300/DT400 Series Loop Resistance and Cable Length on
page 5-19

Table 5-16 DT700/DT800 Series Loop Resistance and Cable Length on
page 5-19

Table 5-17 Cable Connection Between Analog Port and Single Line
Equipment on page 5-20

Table 5-18 Cabling Requirements on page 5-21
Figure 5-4 Connecting the DLC Using Twisted 2-Pair Cable
Multiline Terminal
Twisted 2-Pair Cable
RJ-11
DLC