NEC Univerge SV9100, System Maintenance Manual

Page: 48 / 78

Issue 1.0 UNIVERGE SV9100
3 - 10
S
ECTION
7
SV9100 N
ET
DIM C
OMMANDS
To display the syntax for each command – type in the command.
Example:
nwinfo parkhold
NWINFO PARKHOLD DEL Deletes the specified parkhold
NWINFO PARKHOLD SHOW Shows the specified parkhold information
NWINFO PARKHOLD MODE Changes Networking Parkhold mode [RUN|STOP]
NWINFO PARKHOLD DEBUG Park Hold Trace Information [ON|OFF]
NWINFO PARKHOLD CLEAR Park Hold Clear at All of systems
nwinfo parkhold del
NWINFO PARKHOLD DEL <park group no> <park orbit>
(The values within the brackets are the specific number related to the command, the brackets are not
entered.)
In the NWINFO PARKHOLD DEL command to delete park hold orbit 04 that is within park group 01 you
would enter:
nwinfo parkhold del 01 04
nwinfo debug on should only be used in the lab (or after normal working hours at a customer site), as it
causes a large amount of information to be output and can slow the SV9100.
Enter Function DIM Output
NWINFO Lists the
commands
available NWINFO DEBUG Networking Debug Information [ON|OFF]
NWINFO RSRC Netport Reosurce Controller
NWINFO BLF Blf Memory Dump
NWINFO TCPINIT Dummy CR data send Task refresh
NWINFO TCPDEBUG Networking TCP Information Debug
[ON|OFF]
NWINFO TCPSHOW Networking TCP Information showing
NWINFO CALLINFO
Networking Call Status Information
NWINFO KEEPALIVE Networking KeepAlive Information
NWINFO SYSTEM Networking System Information
NWINFO OPCHG Networking error operation change
NWINFO PARKHOLD Parkhold debug information
NWINFO CALLID
Networking CallID mode selection
NWINFO CHSHOW Show ch condition LED on Dterm
NWINFO ROAMING PHS Roaming Debug
NWINFO TASKINIT NwInfoSend task initialize
NWINFO TASKKP Nwsend Task Keepalive setting
NWINFO VMI Remote VMI information