NEC Univerge SV8100, Programming Manual

Page: 397 / 986

UNIVERGE SV8100 Issue 10.1
Programming Manual 2 - 361
Description
For each DID Translation Table, use
Program 22-12: DID Intercept Ring Group
to
define the first destination group for DID calls.
Depending on the entry in Program 22-09-02 and 22-11-04, the incoming calls route
to the first destination group by the following:

Vacant number intercept (vacant number means that no phone is connected, no
station blade is installed, or the extension number is not defined in Program 11-02)

Busy intercept

Ring-no-answer intercept
If the destination is 0, the calls are forwarded to the trunk ring group defined in
Program 22-11 based on the table assigned to the DID trunk.

If Programs 22-11-05 and 22-11-06 are set, the priority of transferring is in this
order:
Program 22-11-05
+
Program 22-11-06
+
Program 22-12.
For busy and no-answer calls, if the first and third destinations are programmed,
but the second destination is not, the incoming call goes to the third destination
after the first destination. If the first and second destinations are not defined, but
the third destination is, the call goes directly to the third destination.
Program 22 : Incoming Call Setup
22-12: DID Intercept Ring Group
Level:
IN
Input Data
Conversion Table Area Number 01~20
Day/Night Mode 1~8
Item
No.
Item Input Data Default
01
Incoming Group Number
0 (No Setting)
1~100 (Incoming Ring Group)
102 (In-Skin/External Voice Mail or InMail)
103 = Centralized VM
0 (OT)
1 (AU)