NEC Univerge SV8100, Programming Manual

Page: 123 / 986

Programming Manual 2 - 87
Program
11
Description
Use
Program 11-01: System Numbering
to set the system numbering plan. The
numbering plan assigns the first and second digits dialed and affects the digits
an extension user must dial to access other extensions and features, such as
service codes and trunk codes. If the default numbering plan does not meet
the site requirements, use this program to tailor the system numbering to the
site.
Changing the numbering plan consists of three steps:
Step 1: Enter the digit(s) you want to change
You can make either single or two digit entries. In the Dialed Number column in
the
Table 2-3 System Numbering Default Settings on page 2-89 table, the nX
rows (e.g., 1X) are for single digit codes. The remaining rows (e.g., 11, 12,
etc.) are for two digit codes.

Entering a single digit affects all the Dialed Number entries beginning with
that digit. For example, entering 6 affects all number plan entries beginning
with 6. The entries you make in step 2 and step 3 below affect the entire
range of numbers beginning with 6. (For example, if you enter 3 in step 2 the
entries affected are 600~699. If you enter 4 in step 2 below, the entries
affected are 6000~6999.)
Program 11 : System Numbering
11-01 : System Numbering
Level:
IN
CAUTION!
Improperly programming this option can adversely affect system
operation. Make sure you thoroughly understand the default numbering
plan before proceeding. If you must change the standard numbering, use
the chart for
Table 2-3 System Numbering Default Settings on
page 2-89
to keep careful and accurate records of your changes.
Before changing your numbering plan, use PC Pro to make a backup
copy of your system data.