NEC UNIVERGE SL2100, Programming Manual

Page: 541 / 678

Program 82 : Basic Hardware Setup for
Extension
82-01 : Incoming Ring Tone
Level:
MF
Description
Use Program 82-01 : Incoming Ring Tone to set the incoming ring tones, which are the tones a user
hears when a call rings an extension. These tones are grouped into four ring tone Ranges (1 ~ 4), also
called patterns, that consist of a combination of frequencies. (You assign a specific Range to trunks in
Program 22-03 and to extensions in Program 15-02.) Within each range there are three frequency
Types : High, Middle and Low. (Service Code 720 allows users to choose the Type for their incoming
calls.) Each Type in turn consists of two frequencies and the modulation played simultaneously to
make up the tone. These frequencies are determined by their Frequency Number selected in Items 1
and 2 (see below). In this program, you assign the two
Frequency Numbers and Modulation for each
Type, for each of the four Ranges . The chart below shows the default Frequency Numbers for each
Type in each Range .
Input Data
Incoming Ringing Tone Number 1 = Trunk Ring Tone Range 1
2 = Trunk Ring Tone Range 2
3 = Trunk Ring Tone Range 3
4 = Trunk Ring Tone Range 4
5 = Extension Ring Tone Range
6 = Sensor Tone Range
7 = Trunk Ring Tone Range 5
8 = Trunk Ring Tone Range 6
9 = Trunk Ring Tone Range 7
10 = Trunk Ring Tone Range 8
Ringing Tone Type Number 1 = High
2 = Middle
3 = Low
Item
No.
Item Input Data Default
01 Frequency 1 1 = 520 Hz
2 = 540 Hz
3 = 660 Hz
4 = 760 Hz
5 = 1100 Hz
6 = 1400 Hz
7 = 2000 Hz Refer below
02 Frequency 2 1 = 520 Hz
2 = 540 Hz
3 = 660 Hz
4 = 760 Hz
5 = 1100 Hz
6 = 1400 Hz
7 = 2000 Hz Refer below
ISSUE 2.0 SL2100
Programming Manual 2-517
Program
82