1.
Turn the system power off, insert the blank SD Card (1 GB or larger) to the SD slot on the CPU
board.
CPU board
Blank SD Card
SD slot (J12)
Figure 3-13 Inserting the SD Card
2.
Turn the power on, enter the Program Mode then PRG90-03.
Program Mode
9003-01
Data Save
Figure 3-14 PRG90-03 Display (12TXH/24TXH-A1)
Program Mode
Base Service OP1 OP2
90-03-01
Data Save YES:1 1
Figure 3-15 PRG90-03 Display (12TXH/24TXH-B1)
3.
Dial
1
and press
Hold
key.
4.
When the data backup to the SD Card is completed, the display will be changed to the next PRG.
9003-01
SavingSystemData
9004- M
,
tenanc
Load Data
Figure 3-16 PRG90-04 Display (12TXH/24TXH-A1)
Saving System Data
90-04- M
’
tenance
Load Data |01
back Select
Figure 3-17 PRG90-04 Display (12TXH/24TXH-B1)
5.
Remove the SD Card and exit from the Programming Mode.
The saved data on SD Card cannot be edited by the PC.
SL2100
ISSUE 1.0
3-6
System Start Up
Summary of Contents for UNIVERGE SL2100
