NEC UNIVERGE SL2100, Hardware Manual

Page: 143 / 174

6. When the system has completed reloading the software (about one minute), the RUN LED is
flashing green on the CPU board and the connected Multiline Telephone's display will show the
Time & Date and Extension Number.
TUE18 7:27PM
200
Figure 3-3 Display Indication (Idle) (12TXH/24TXH-A1)
11-10 WED 1:49PM
200
Menu Dir VM:00 CL:00
Figure 3-4 Display Indication (Idle) (12TXH/24TXH-B1)
1.2.2 Perform a Hot Start
This section describes how to load system software from flash memory, and the customer data from
RAM memory.
System Software and customer data are loaded from flash memory.
If Expansion Chassis are installed, turn the power on/off in the order of
Expansion 2 Chassis, Expansion 1 Chassis and then Main Chassis.
To perform a Hot Start;
1. Turn the system power off.
2. After it has powered off, turn the power switch back to ON. Wait approximately one minute.
3. When the system has completed reloading the software, the RUN LED is flashing green on the
CPU board, and the connected Multiline Telephone's display will show the Time & Date and
Extension Number as
Figure 3-4 Display Indication (Idle) on page 3-3 .
ISSUE 1.0 SL2100
Hardware Manual 3-3