NEC UNIVERGE NEAX 2000 IPS, Configuration Manual

Page: 55 / 96

Chapter 4 Circuit Cards Line/Trunk (LT) Cards
NEAX 2000 IPS Configuration Guide
NDA-24347, Issue 1
Page 45
Line/Trunk (LT) Cards
Table 4-3 shows a summary of the Line/Trunk (LT) cards for NEAX 2000 IPS. The LT cards may be installed in
Slot 00 to 11 of PIM 0-7, with the following conditions:
• Maximum 64 ports per PIM
Table 4-3 Line/Trunk (LT) Cards
ABBR. NAME CODE
PART
NUMBER
PORT REMARKS
IP PAD
SPN-32IPLA IP PAD
SC-3013 IXS IP PAD PROG-A1
151227 32
IP Interface Card
• For IP PAD
• Maximum of two without FP system
• Maximum of two per FP system
• Maximum of eight per system
SPN-16VCTA IP PAD
IP-TRK BUS CA
SP-3636 VCTA VC PROG-A 151226 0
16-channel CODEC Card
• For IP PAD
• Maximum of two per 32IPLA card
• Minimum of one 16VCT is required per
32IPLA.
LC
PN-8LCAA 150114 8
8-line Analog Line Circuit
• Message Waiting Control: Eight circuits
• Momentary Open: Eight circuits
• Loop Resistance: Maximum 600
Ω
including telephone set
PN-4LCD-A 150216 4
4-line Analog Line Circuit
• Message Waiting Lamp Control
• Momentary Open: One circuit
• Loop Resistance: Maximum 600
Ω
including telephone set
PN-4LLCB 151220 4
4-line Long Line Circuit
• Works in either mode:
• Long Line Station
• Caller ID
• Loop Resistance: Maximum 2,500
Ω
including telephone set
• PZ-PW122 is required.