NEC SV8500, Manual

Page: 3316 / 3438

VOL.3-829
CHAPTER 4 CONFIGURATION SETUP
Note 1:
Do not go the handset off-hook when headset is used.
Note 2:
The priority order of Ringing Tone settings is as follows.
• 1st Priority: Ringing tone settings by “2. Directory (Not Earlier than FW 2.0.0.0 but Earlier Than
FW 5.0.0.0)” - “2.Edit” - 8.Ringing Tone/9. Illumination
• 2nd Priority: Ringing tone settings by “2. Directory (Not Earlier than FW 2.0.0.0 but Earlier Than
FW 5.0.0.0)” - “3.Group Setting” - 2.Ringing Tone/3. Illumination
• 3rd Priority: Ringing tone settings by “5. Setting (Not Earlier than FW 2.0.0.0 but Earlier Than FW
5.0.0.0)” - “1.User Setting” - 4.Ringing Tone/5. Illumination
Note 3:
In the case of power failure for backlight, the terminal follows the Telephony Server’s direction discarding
the terminal’s setting.
Note 4:
To make the font size change effective, once exit the configuration menu by pressing the software key for
“Exit.”
Note 5:
Tone Type 1 rings when Automatic is selected. If a ring tone has been set in the Directory menu, it will be
prioritized over this setting except DT710.
Note 6:
The lamp illuminates Red when Automatic is selected. If an illumination has been set in the Directory menu,
it will be prioritized over this setting except DT710.
Note 7:
A tone will be provided if Automatic has been set.
Note 8:
12-Hour Indication is applied when Automatic has been set.
Note 9:
A setting for Enable is applied when Automatic has been set.
3. Data Backup/Restore
Makes backup of terminal data or
restores from backup file.
-
X X X
1. Data Backup Saves the terminal setting to backup file. PersonalD
ata.tgz
2. Data Restore
Restores the terminal data by reading
out the saved backup file.
PersonalD
ata.tgz
X X X
3. Server Address Sets IP address of FTP/TFTP server. 0.0.0.0 X X X
4. Protocol
Specifies the protocol for file
downloading.
FTP X X X
1. FTP FTP is used.
2. TFTP TFTP is used.
5. FTP Settings Sets data for accessing FTP server.
- X X X
1. User ID Sets user ID for login to FTP server.
2. Password Sets password for login to FTP server.
3. Folder
Specifies the directory to save backup
file.
5. Setting
(Continued)(Not Earlier than FW 2.0.0.0 but Earlier Than FW 5.0.0.0)
Parameter Description Default
DT750
Series DT730
Series DT710
Series