NEC SV8500, Manual

Page: 2748 / 3438

VOL.3-261
CHAPTER 2 TERMINAL-RELATED DEVICES
8. Distributed Communication Server (DCS)
8.1 General
8.1.1 Outerview
This section covers how to install and maintain the Distributed Communication Server (DCS), an optional remote
server system. The figure below shows the outer view of the DCS.
8.1.2 Related Reference Manuals
This manual does not cover the information related to the Telephony Server. If you need such information,
please refer to the following manuals, too:
Table 2-1 Related Reference Manuals
MANUAL CONTENTS
UNIVERGE SV8500
Installation Manual This manual covers the following procedures, required for:
• the installation of the Telephony Server and other necessary equipment.
• the initial power-on and start-up of installed Telephony Server.
• confirmation of the system’s normal operations (post-installation test).
UNIVERGE SV8500
Operations and Maintenance
Manual This manual explains how to operate and maintain the installed system. The contents in-
clude:
• The way to detect/diagnose a fault.
• Measure(s) to be taken in case of fault encountering.
• The outline of maintenance commands and their parameters.
• Other operating procedures of the Telephony Server and its routine maintenance, etc.
UNIVERGE SV8500
Circuit Card Description This manual describes the functional outline, mounting location, lamp indications and
switch setting, etc. of the circuit cards used in the Telephony Server.
NEC
Distributed
Communications
Server
Fusion Networking