VOL.2-2088
SR-MGC(E)
Note 3:
To confirm that shutdown is complete, check the PWR lamp. When the auto-shutdown does not work,
press and hold the CPU PWR switch for four seconds to turn off the power forcibly.
Note 4:
If you want to operate an SR-MGC(E) with off-line mode, turn it on with the MODE switch set to on.
If you activate an SR-MGC(E) with off-line mode, the following settings apply:
• SR-MGC(E) is set up without running TP and SP programs.
• An Ether1 IP address comes to 192.168.0.2/24.
Connect the Telephony Server Maintenance Menu/PCPro Tools (
) to Ether1 so that you can main-
tain the SR-MGC(E). But Telephony Server Maintenance Menu/PCPro Tools may not be available de-
pending on the system state.
Note 5:
Telephony Server Maintenance Menu is available since FP85-109 S6. For FP85-108 S5 or earlier, use
only PCPro tools.
Note 6:
Do not connect any cable to the Ether2, Ether3, and Ether4 connectors.
(3)
Rear panel
Part
Condition
Description
Remarks
PWR switch
-
Hold down “O” to turn off.
-
Hold down “l” to turn on.
AC power inlet
-
Connected with an attached three-polar
grounded AC power cable
(Cable Length: 3 m [9.8 ft.])
Fix the cable with
the stopper to pre-
vent it from falling
out.
PWR alarm lamp
ON (red)
Failure in power.
OFF
Works properly.
FAN1 alarm lamp
ON (red)
FAN1 fails.
OFF
FAN1 works.
FAN2 alarm lamp
ON (red)
FAN2 fails.
OFF
FAN2 works.
Cooling FAN1
-
A FAN for cooling the device.
Replaceable during
operation.
Cooling FAN2
-
A FAN for cooling the device.
Replaceable during
operation.
Summary of Contents for SV8500
