NEC SV8500, Manual

Page: 2221 / 3438

VOL.2-1968
VS-32 Conference Server
SETUP
Basic settings of VS-32 Conference Server IP relations such as IP Addresses, Subnetmask, DRS and DHCP used
in VS-32 Conference Server are assigned by this command. This command must be executed when starting up
a VS-32 Conference Server from the initial setting.
1. Setting Basic IP data
Note:
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
mand.
Note 1:
About IP address of DRS (Telephony Server), refer to “Registration Destination of IP Devices/Stations” in
INTRODUCTION of Installation Manual.
VS-32> SETUP IP
Input DHCP(Dynamic host Control Protocol)
parameter ENABLE or DISABLE
DHCP : DISABLE
Input IP address
IPADDRESS: 10.10.10.150
Input Netmask
NETMASK: 255.255.255.0
Input DEFAULTROUTE
(DEFAULT ROUTE is the gateway to other subnet.).
DEFAULT ROUTE : 10.10.10.254
Input DRS address parameters.
(If you need to setup secondary DRS address,
you may use ‘SET DRSADDRESS’ command.)
Primary DRS ADDRESS : 10.10.10.3
STEP1:Enable or disable DHCP server.
If DHCP Server is set to ENABLE, command in-
put will be finished.
STEP2:Enter an IP address for VS-32 Conference
Server.
STEP3:Enter a subnet mask for the VS-32 Con-
ference Server.
STEP4:Enter an IP address for the default route.
STEP5:Enter a DRS address.
Note 1
This setting is available after rebooting the sys-
tem.
STEP1
STEP2
STEP3
STEP4
STEP5