NEC SV8500, Manual

Page: 2133 / 3438

VOL.2-1880
MG-SIP16 [SCA-16SIPMG(US)]
22.5 Maintenance Console Commands
22.5.1 How to Use Maintenance Command
Note:
“DRS (Device Registration Server)” used in this section refers to the Telephony Server. The Telephony
Server acts as DRS for MG-SIP16 using Proprietary Protocol.
• Connection Settings
A communication between Maintenance Console and MG-SIP16 is established via communications soft-
ware.
Note:
For Windows computers, HyperTerminal was bundled with Windows 95 to Windows XP. This section ex-
plains the procedure for setting data by using HyperTerminal as an example. For Windows Vista or later
operating systems, prepare a communications/terminal software yourself and assign the configuration data
referring to the description for HyperTerminal.
When the program is activated, messages are displayed. After a prompt “
->
” is displayed, enter “
config
”
after the prompt to login.
The following prompt appears, indicating that the Maintenance Console command entry is ready:
An example of indication is shown below:
-> config
MG(SIP) >
ALM PWR
ON
LINE
Ether 1 Ether 2
100M LINK 100M LINK
RESET
CONSOLE
MG-SIP
Maintenance Console
MG(SIP) > set default
Config data default set.
.........................
MG(SIP)>
User Input Command
Reply Message
Prompt