NEC SV8500, Manual

Page: 2047 / 3438

VOL.2-1794
MG-SIP16 [SCA-16SIPMGA/MG-16SIPMGA]
[Set IP Address and Port Number of DRS]
STEP 4: Assign the IP address and port number of DRS by using
set drsaddress
command.
Note 1
Note:
unit(0), unit(1), unit(2), and unit(3) represent primary, secondary, tertiary, and fourthly respectively.
Note 1:
About IP address of DRS (Telephony Server), refer to “Registration Destination of IP Devices/Stations” in
INTRODUCTION of Installation Manual.
[Set SIP Server Data]
STEP 5: Set SIP Server data by using
set sipserver
command. This data can be assigned by using IP
address or Full Qualified Domain Name (FQDN).
When IP address (=0) is selected
:
MG(SIP) > set drsaddress
DRS unit(0)
DRS IP address: 172.16.0.1
DRS port number(1024-65535): 3456
DRS unit(1)
DRS IP address: 0.0.0.0
DRS port number(1024-65535): 3456
DRS unit(2)
DRS IP address: 0.0.0.0
DRS port number(1024-65535): 3456
DRS unit(3)
DRS IP address: 0.0.0.0
DRS port number(1024-65535): 3456
• Assign the IP address of DRS.
• Assign the UDP port number DRS (Default: 3456).
• Skip this by pressing Enter key.
• Skip this by pressing Enter key.
• Skip this by pressing Enter key.
• Skip this by pressing Enter key.
• Skip this by pressing Enter key.
• Skip this by pressing Enter key.
MG(SIP) > set sip_server
SIP server type(0=IP address/1=FQDN):0
SIP server IP address: 192.168.100.100
SIP server port number(1024-65535): 5060
Strict or Loose(0/1): 0
Domain Name(MAX128):_
• When IP address (=0) is selected.
• Assign the IP address of the proxy server (default: 0.0.0.0).
• Assign the port number of the proxy server (default: 5060)
• Select a Strict router or Loose router for the proxy server (default:
0).
0: Strict route
1: Loose router
• Input a string that specifies the service provider in maximum of
128 characters.