NEC SV8500, Manual

Page: 1893 / 3438

VOL.2-1640
MG-SIP96
Note: The conditions of this command are as follows.
• Assign this command adjusting to the specifications on the SIP network where MG-SIP96 connects.
• At DTMF Mode Negotiation/Out-Band, the payload type 103 cannot be used.
• Note that the sum of DTMF Duration and DTMF Pause values must be specified more than 120ms. If not,
the following error message is displayed.
(21) h245_base_port_no
Setting of the base port number for H.245 TCP server
This command is used to specify the port number for H.245 TCP server.
[Setting Example]
Note:
Normally this command is not required to be changed.
(22) hc_alarm
Setting of the alarm transmission destination
This command is used to set the alarm function which is activated to send a warning tone when a health
check timeout occurs.
[Setting Example]
Note: Normally this command is not required to be changed.
Input DTMF Pause value.(ms)
(30-240(default=100)):100
Specify DTMF Pause.
(30 to 240ms/Default: 100ms)
Input parameter error,
reason [DTMF Du DTMF Pause<Min120ms]
MG(SIP)> set h245_base_port_no
Input H245 base Port Number.
(1024-64511(default=40000)):40000
Assign the port number for H.245 TCP
server.
(Default: 40000)
(receiving side of MG-SIP96)
MG(SIP)> set hc_alarm
Select H/C Alarm type.
0=IPX and SIP side enable(default)
1=IPX side enable
2=SIP side enable
3=disable
Input:0
0: Warning tone is sent to the Telephony Server
and SIP sides (Default).
1: Warning tone is sent to the Telephony Server
side only.
2: Warning tone is sent to SIP side only.
3: disable