NEC SV8500, Manual

Page: 1688 / 3438

VOL.2-1435
MG-SIP128 [MG-128SIPMGG]
Note 4:
The conditions of “SIP telephony service function” are as follows.
• When “SIP telephony service function” is enabled by the SET command “sip_tel_service”, “enable” is dis-
played, as well as enablement/disablement of the following settings:
Replaces function
Hold [a=inactive] function
Hold [put off hold] function
REFER/NOTIFY function
3PCC function
• For “3PCC function(codec)”, the selected data by the SET command “sip_tel_service” is displayed.
• When “SIP telephony service function” is disabled by the SET command “sip_tel_service”, the following is
displayed:
“SIP telephony service function: disable”
Then nothing is displayed below “SIP telephony service function: disable”.
• “3PCC function” and “3PCC function(codec)” are displayed only when 3PCC function is enabled by the
SET command “sip_tel_service”.
3=Port Config Data
Port Config Data=Port configura-
tion data
4=SIP Config Data
SIP Config Data=SIP configura-
tion data
5=Route Config Data
Route Config Data=Route infor-
mation configuration data
9=Exit
End of show command
Select a reference number : 5 Select “5”.
Ether[1]
Data currently configured to each
port number will be displayed.
Route type:Static
No|Gateway Address|Destination network/Prefix
-------------------------------------------------
1 |192.168.0.254 |172.16.0.0
/16
Ether[2]
Route type:Static
No|Gateway Address|Destination network/Prefix
-------------------------------------------------
1 |192.168.0.254 |0.0.0.0
/0
When IPv6 (=1) is selected by “set
ip_version” command, Gateway
Address and Destination network
will be shown in IPv6 address for-
mat.