NEC SV8500, Manual

Page: 1569 / 3438

VOL.2-1316
MG-T1(SIP) [SCA-24DTIA]
This command is used to enable/disable the Training Feature mode of Echo Canceller. Echo Canceller Fea-
ture is used to prevent initial Echo (ranging from 500 to 1ms) occurred in the beginning of speech to the
Telephony Server.
7. SET Δ FAXERRORDETECT Δ P1
This command is used to specify the available time to be switched to FAX mode.
Note:
To make this assignment effective, execute the SAVE command and restart before exiting the maintenance
command.
8. SET Δ
HC_RCV_TIMER
Δ P1
This command is used to specify a value recognized as timeout in receiving health check.
Note:
To make this assignment effective, execute the SAVE command and restart before exiting the maintenance
command.
9. SET Δ INTERFACE
This command is used to specify the communication speed of LAN interface. Be sure to assign this data
adjusting to the network devices (router, switch, or HUB, etc.). This data can be set also in
SETUP SP com-
mand.
MG-T1(SIP)> SET EC_TRAINING ON
P1 : Specify the following:
ON =Training function is valid
OFF =Training function is invalid
ONCE =Training function is valid only once (default)
EC Training Feature setting succeeded.
Result is displayed.
MG-T1(SIP)> SET FAXERRORDETECT 1
P1 : Specify the available time to switch to FAX.
0 =FAX switching is unavailable.
1-5 =Available time to be switched to FAX (minutes)
OFF =Always-on FAX switching
FAX Enable Timer setting succeeded.
Result is displayed.
MG-T1(SIP)> SET HC_RCV_TIMER 120
P1 : Specify a time (second) recognized as timeout in
receiving health check.
120-300 =Available time.(Default: 150)
Impedance setting succeeded.
Result is displayed.
MG-T1(SIP)> SET INTERFACE
SPEED(AUTO/100M/10M):100M
1) Select the communication speed of LAN interface
AUTO =Auto negotiation (default)
100M =100Mbps fixed mode
10M =10Mbps fixed mode
DUPLEX(FULL/HALF):HALF
2) Select duplex mode (*not displayed when SPEED=AUTO)
FULL =Full duplex
HALF =Half duplex
Ethernet Speed setting succeeded.
Result is displayed.